I am skipping a bit here, but the bottom line is that I’ve been working with several types of sensors and writing Arduino code for them. I did a few exercises before hooking Arduino and sensor input to Grasshopper using the FireFly library by Andrew Payne in order to drive the geometry in there. Basically, for my thesis I was developing a curtainwall system that is driven by sun tracking device and light sensors and for the presentation in the virtual (GH) environment I used FireFly to drive the aperture motions within GH. Further on I was going to manufacture (partially) one of the panels of this curtain wall. The images here are an aggregation of the stuff that I collected over this period.
No comments:
Post a Comment